Autoleveller

Excelent...

Can't wait the new version.

Don't know if this can help, but I found out that lower the feed rate when probing, better are the results.

Milling with 0.07mm.

I was thinking about becoming a member but I was not sure if would work correctly.

I'm from Brazil, and my eagle, pcbgcode, linuxcnc are all in mm!

Checked that too...

I know the fixture problems. I use bolts tightened with clamps and I am sure it does not move. I used the same position in the bed, with the same parameters with PCBZCorret with sucess https://github.com/MarcusWolschon/PCBZCorrect/tree/master/PCBZCorrect I checked and it happens always in the same p...

I am having the same problem.

running leveller 7.7 from linux java.
Every time, in the same spot I got air lines.

Already tried lower feed rate, fixing, increse resolution, decrease.. Any suggestions?