Autoleveller

Thanks both of you for your help - now sorted.

I hadn't been reading the messages in Mach3 which indicate the re-zeroing routines when using a probe file.

Perhaps some very, very basic step by step instructions would be useful for absolute beginners (like me).

Thanks,

Pinpres

After some careful following of the steps detailed above I get the follwoing results. If I DON'T tick “create probe file only” I can engrave normally with correct depth of cut. If I DO tick “create probe file only” and then use this file to make a new engraving file as in steps 1 - 9 above, the cut ...

Hi, I have used autoleveller in the past (free version) with some success. Now after a few months with all brainpower taken up with a house move I got back to pcb making and bought the paid for version. Unfortunately when I click on the "Create Levelled Code" nothing happens. Here is the situation: ...