Autoleveller

Thanks James. I'll check the first probe point on my next run, I may have been mistaken if you say it should be near enough to 0. Writing guides does take ages, I fully sympathise. I will be writing up our Science Club "Illuminated Necklace" project in the coming weeks, including your AutoLeveller m...

Thanks for the reply, I always do 2 stage Autolevelling partly because of multiple milling processes on the one surface but also so that I CAN stop and resume the program (to fine tune cut depth by entering an altered Z in the DRO). I thought Autoleveller's first probe point would ALWAYS be Z=0mm? B...

Great to be able to see the gerber BUT... 2 problems in 0.9.0 I can't resize the window to fit myCNC machine's old 1024x768 screen - the right side is cut off which of course has the "autolevel" button on it. I have gone back to 0.8.5 for now. I hope this is fixed soon! and There is no probe data at...

The guide says to refer to the table of probe data...
I don't get the table of probed data at the top of my GCode - V0.8.5 or 0.9.0
Should it be there? I am using Mach3 output.
Thanks