Search found 2 matches
- Wed Apr 16, 2014 12:57 am
- Forum: Bug Report
- Topic: Some Z-Moves are not corrected
- Replies: 3
- Views: 7971
Re: Some Z-Moves are not corrected
I did just discover one workaround in case anyone else is running into this problem. I set my "Start Depth" for the engraving toolpath at .0001" instead of 0". This is a small enough difference that I or my machine will barely notice, but autoleveller handles it properly now. FYI I am using Vetric A...
- Wed Apr 16, 2014 12:35 am
- Forum: Bug Report
- Topic: Some Z-Moves are not corrected
- Replies: 3
- Views: 7971
Some Z-Moves are not corrected
Was engraving a slightly bowed piece of metal, used Autoleveller to contour the engraving to match. Engraving was going very well, except for the final pass of the lettering. Towards the higher portions of the piece, the bit was driving much further that it should be on the corners of letters. Did a...