On a recent project I've noticed these strange extra circles and off-centered circles popping up in my g-code. They are always connected to another circle that WAS in the original code. That original circle is also offset from it's original g-code. I've looked at the code side by side and have found the numbers to be off.
Anyone seen this before? Am I doing something incorrectly?
Extra Circles
Re: Extra Circles
You are seeing numerical noise caused by fragments of track data which are of zero length.
As sucjh they can be interpreted as arcs of very tiny radius.
I have had some bad experiences with these events with professional CAM software.
As sucjh they can be interpreted as arcs of very tiny radius.
I have had some bad experiences with these events with professional CAM software.