Bad character "%"

Report problems here
Post Reply
paulnd
Posts: 6
Joined: Thu Apr 17, 2014 4:33 pm
Location: London

Bad character "%"

Post by paulnd » Mon Jun 30, 2014 5:21 pm

Hi,

I use Vectric Aspire to generate a gcode file for LinuxCNC and Aspire starts and ends the file with a "%". Autoleveller inserts the probing routine before the "%" which then causes a bad character error in LinuxCNC because the start "%" is in the wrong place.

All seems to be ok if I manually delete the "%" or move it back to the start of the file.

regards

Paul

daedelus
Site Admin
Posts: 363
Joined: Tue Oct 01, 2013 1:41 pm
Location: London, UK
Contact:

Re: Bad character "%"

Post by daedelus » Mon Jun 30, 2014 7:54 pm

thanks Paul,

I have logged it, and will fix it in the next release.
http://www.autoleveller.co.uk/. Software to probe and adjust a GCode file for PCB's or any probe-able surface.

http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.

-James

Post Reply