Bad character "%"
Posted: Mon Jun 30, 2014 5:21 pm
Hi,
I use Vectric Aspire to generate a gcode file for LinuxCNC and Aspire starts and ends the file with a "%". Autoleveller inserts the probing routine before the "%" which then causes a bad character error in LinuxCNC because the start "%" is in the wrong place.
All seems to be ok if I manually delete the "%" or move it back to the start of the file.
regards
Paul
I use Vectric Aspire to generate a gcode file for LinuxCNC and Aspire starts and ends the file with a "%". Autoleveller inserts the probing routine before the "%" which then causes a bad character error in LinuxCNC because the start "%" is in the wrong place.
All seems to be ok if I manually delete the "%" or move it back to the start of the file.
regards
Paul