Rapid changing speed
Posted: Mon Nov 24, 2014 7:11 am
Hello forum,
My mill seams to change rapid speeds a small but vary noticeable amount between some probes, I know this seams strange but i am going to look into it and see if there is a patten I don't know what software is at fault.
I am using Mach3.
Kind Regards
David.
My mill seams to change rapid speeds a small but vary noticeable amount between some probes, I know this seams strange but i am going to look into it and see if there is a patten I don't know what software is at fault.
I am using Mach3.
Kind Regards
David.