Mach 3 error on M41

Help for setting up and using
Post Reply
Site Admin
Posts: 381
Joined: Tue Oct 01, 2013 1:41 pm
Location: London, UK

Mach 3 error on M41

Post by daedelus » Wed May 13, 2015 12:57 pm

Hi all, I got an email the other day about Mach 3 locking up around the M41 line. Mach 3 says something like "error in getcontext". This is just with 0.8.x. 0.7.x is fine apparently.

Have any Mach 3 users experienced anything similar? Software to probe and adjust a GCode file for PCB's or any probe-able surface. A short guide to setting up the probe.


Post Reply