I apologize if this has been posted alredy but I did a search and couldn't find any answer.
I want to set up Mach3 to allow for Manual Tool Change, so that in one G-Code I have different bits one after another. When Mach3 pauses to allow for the tool to be changed and waits for Cycle Start to be pressed to continue with the G-Code I need to re-probe Z to set the new length of the tool.
My question is: does this affect Autoleveller and how should I proceed when calibrating the height map?
Thanks
Cheers
Sonolink
Manual Tool Change
Re: Manual Tool Change
Thanks a lot for all your replies!!
- Country_Bubba
- Posts: 124
- Joined: Wed Oct 02, 2013 3:07 pm
- Location: LaGrange, GA USA
- Contact:
Re: Manual Tool Change
I didn't answer when you posted your question as I do not use Mach!
I can only say that I use Turbocnc and do a single probe and let the post processor for Eagle do all the tool change coding.
I would expect it to work in a very similar way in Mach, but YMMV!
I can only say that I use Turbocnc and do a single probe and let the post processor for Eagle do all the tool change coding.
I would expect it to work in a very similar way in Mach, but YMMV!
Art
Country Bubba
Country Bubba