Hello Everyone.
To begin with, I am using Mach3 V3.043.066.
Recently, I updated my CNC milling machine with a WiXHC Ethernet motion control board, all because USB connection with my previous board was really unstable, and I ended up crashing my machine a few times due to a wiggling cable or noise in the system.
Now that I have upgraded my machine with a few more things, like stepper motors with encoders and such, I wanted to test the accuracy of the whole thing by tracing some PCBs, so I gave Autoleveller a go and things didn't really work out.
I have never used the automatic probe feature, I go old school on my milling and get the mill close enough until I see a contact being made on the screen. So I don't know how reliable the Autoleveller thing is.
NOW THE PROBLEM:
When I start doing the probing with the PFG file, it goes fine and dandy until I check the raw data file, and it is all WRONG. The data being saved is the same number on X Y and Z values, as if it were just saving the same point regardless of where the machine moved.
I have looked all over, but I can't finds any answers. I have looked at my settings, and they look just fine, the machine does its milling, but the probing part is a mess.
Any ideas on how to solve this?
Mach3 + WiXHC Ethernet Control Board + Autoleveller (Not Working)
-
- Posts: 2
- Joined: Sun Feb 09, 2020 9:32 pm