Hi.. I work in desing and make of PCB for electronic circuit (is my hobby)
For make my prototypes I work whit LinuxCNC v. 2.8.4 and my electronic controller for CNC is Mesa 7I96 card
the software i work is Kicad + FlatCAM.
But I have problems with AutolevellerAE v.0.9.5u2.
when the axis X go to the right, all work fine, the height is correct and work perfect but when the Axis X change the direction, the Axis Z gou up a little more of the normal and no work fine and when the axis X change the direction again at the righ the axis Z go down and work fine again
This picture is whit Autoleveller
This picture is unautoleveller
The last picture my cnc work fine because is a small PCB
Someone know what going on?
Thanks you everyone
[SOLVED] Autoleveller no work fine when the axis X change of direction
[SOLVED] Autoleveller no work fine when the axis X change of direction
Last edited by Nest on Wed Jun 28, 2023 4:57 pm, edited 1 time in total.
Re: Autoleveller no work fine when the axis X change of direction
Hi, I fix the problem... the problem was the backlash parameter in the axis Z, I deactivate this option and now work fine
At now the my CNC make PCB like that
This software work really great, thanks you so much
At now the my CNC make PCB like that
This software work really great, thanks you so much
- Country_Bubba
- Posts: 124
- Joined: Wed Oct 02, 2013 3:07 pm
- Location: LaGrange, GA USA
- Contact:
Re: [SOLVED] Autoleveller no work fine when the axis X change of direction
Hi,
Glad you were able to figure it out! Some of the settings can be inter reactive and hard to chase down.
Good Job
Glad you were able to figure it out! Some of the settings can be inter reactive and hard to chase down.
Good Job
Art
Country Bubba
Country Bubba