I am running g-code produced by the demo version of autoleveller for the first time. I am running it on linuxcnc.
I touch the Z axis off about 10mm above the board as per the instructions on this site. When I run the code, the Z axis moves down and the bit makes contact with the board and stops. I then get the error "Probe is already tripped when starting G38.2 or G38.3 move".
Any ideas what I am doing wrong?
I know the probe is working because I can see a response on the HAL meter plus the gcode would not stop if it is not working.
Probe is already tripped when starting G38.2 or G38.3 move?
Re: Probe is already tripped when starting G38.2 or G38.3 move?
I seem to remember that happening to me once or twice, and I just put it down to some quirk of LinuxCNC.
Running the code again from the start seemed to clear the problems for me at least.
Running the code again from the start seemed to clear the problems for me at least.
http://www.autoleveller.co.uk/. Software to probe and adjust a GCode file for PCB's or any probe-able surface.
http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.
-James
http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.
-James
Re: Probe is already tripped when starting G38.2 or G38.3 move?
Same here. I ran it again (after exiting Linuxcnc) and it just ran.