AE interface problems
Posted: Fri Dec 29, 2017 6:50 pm
There seems to be something wrong with the interface of Autoleveller AE since version 0.9.2. I can't believe I am the only one seeing this, but apparently no one else has complained yet.
Issue 1: The main menu does not work half of the time. I click "File", the submenu opens ("Original G-code", "Clear OGF", "Raw probe file" etc.), but the submenu is not clickable. If I exit the menu and open it again, it may or may not start working.
Issue 2: Once I open an RPF file, the "Mesh" tab is greyed out. I cannot go back to the "Mesh" tab until I close the RPF file.
P.S. I tried to make a video recording of the issue #1, but now I can't make it fail! I have been clicking the menu for a few minutes, and it just keeps working.
Issue 1: The main menu does not work half of the time. I click "File", the submenu opens ("Original G-code", "Clear OGF", "Raw probe file" etc.), but the submenu is not clickable. If I exit the menu and open it again, it may or may not start working.
Issue 2: Once I open an RPF file, the "Mesh" tab is greyed out. I cannot go back to the "Mesh" tab until I close the RPF file.
P.S. I tried to make a video recording of the issue #1, but now I can't make it fail! I have been clicking the menu for a few minutes, and it just keeps working.