I also use a very very slow plunge rate to probe the pcb .
The values of the z axis are looking good to me so I really don`t know what is wrong but I will investigate
Search found 2 matches
- Fri Mar 18, 2016 4:10 pm
- Forum: non-CNC Stuff
- Topic: Autoleveller generates bad gcode
- Replies: 3
- Views: 7853
Re: Autoleveller generates bad gcode
I use mach 3 and the pcb is clean.
I also use a very very slow plunge rate to probe the pcb .
The values of the z axis are looking good to me so I really don`t know what is wrong but I will investigate
I also use a very very slow plunge rate to probe the pcb .
The values of the z axis are looking good to me so I really don`t know what is wrong but I will investigate
- Tue Mar 08, 2016 10:26 pm
- Forum: non-CNC Stuff
- Topic: Autoleveller generates bad gcode
- Replies: 3
- Views: 7853
Autoleveller generates bad gcode
Hello, I have a problem with autoleveller. I probed a gcode file for a pcb where I set the target depth to 0.02mm. I don`t know if this is deep enough to remove the copper but I wanted to test it. But if I run Autoleveller with the gcode and probe the new file and start milling/isolation it goes alm...