Autoleveller

Thank you very much for the information, it has been very useful. I am reading the CNCjs documentation so I can attach it to the Autoleveller. I will probably be asking again. Thank you very much

Analyzing the code, I find the following reference that when I try to execute it, it does not correspond to GRBL
#5000=#5422

What does it refer to?

Hello, thank you very much for your prompt reply. CNCjs uses g38.x, so I tried the code generated for linux, and it seems to work, although it is not the same as the one generated by CNCjs. Z-Probe G91 G38.2 Z-10 F20 G90 Set the active WCS Z0 G10 L20 P1 Z10 Retract from the touch plate G91 G0 Z4 G90...

My question is very basic, since I am new to this subject. I currently use CNCjs to run the Gcode on my CNC and I don't see a way to couple it with Autoleveller. All the documentation I found is referred to use Mach3, and the truth is that I could not make it work with the board I have which is a RA...