New Table Setup

Discuss all things

Moderator: Country_Bubba

Post Reply
daedelus
Site Admin
Posts: 387
Joined: Tue Oct 01, 2013 1:41 pm
Location: London, UK
Contact:

New Table Setup

Post by daedelus »

Today I uploaded a new page to the site which shows the changes I made to my CNC table at the weekend.

http://www.autoleveller.co.uk/table-setup/

This t-slot table makes it quick and easy for me to secure boards. Please take a look and let me know your opinions, good or bad :)
http://www.autoleveller.co.uk/. Software to probe and adjust a GCode file for PCB's or any probe-able surface.

http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.

-James
User avatar
Country_Bubba
Posts: 124
Joined: Wed Oct 02, 2013 3:07 pm
Location: LaGrange, GA USA
Contact:

Re: New Table Setup

Post by Country_Bubba »

That looks fantastic! It should make the job a whole lot easier in the future.

I have done basically the same thing using a vacuum table. The only difference is I use G54 for X0Y0 at the left hand corner and G55 for the right hand corner. When I made the fixture, I saved the values. Now when I power up the machine, home it, and then load the offsets, am ready to go! Post processors for Eagle is setup to mill G54 on top, G55 on the bottom!

Oh, also have a touchoff plate that is located in a fixed location on machine coordinates to do tool length offsets for drilling etc:})

Looks great and am sure you will find it easier to make boards now.
Art
Country Bubba
Post Reply