RPF failure
Posted: Tue Jul 21, 2020 1:00 pm
Hello,
I'm using AutolevellerAE 0.9.5u2. I load OGF, update mesh and generate PFG.
Then in Mach3, I load the PFG file, do the job and try to open RPF in AutolevellerAE.
I get the error "the number of points per row is not the same for each row".
I double checked that points per row is the same for each row.
What can I miss?
Thanks.
I'm using AutolevellerAE 0.9.5u2. I load OGF, update mesh and generate PFG.
Then in Mach3, I load the PFG file, do the job and try to open RPF in AutolevellerAE.
I get the error "the number of points per row is not the same for each row".
I double checked that points per row is the same for each row.
What can I miss?
Thanks.