Some of the questions are answered on the FAQ page: http://www.autoleveller.co.uk/faqs/ but I am particularly interested in anyone with any unlisted controller such as UCCNC or a beaglebone board etc. and whether you can get AE to work for you and if you needed to work around some issue to do so.
From what I know:
- Parallel port cards have fewer/no issues compared with USB ones
- LinuxCNC works
- TurboCNC works with AE but AL will need some tweaking first. For advise on this and any other TurboCNC questions, Art Eckstein "Country Bubba" is the man to ask.
- Mach3 works (if you have a USB card, you may need to write a macro to get the correct probe results, see the FAQ page for more on this)
- Mach4 also works but again you will probably need to write a macro, see FAQ page for more
- GRBL doesnt work off the bat but if you can find some control software to record the probe results to file, then it should work with AE