Hi, when i run the created autoleveller gcode in mach3, it will prompt me for a probe file. It creates the file but its empty..
latest version of autoleveller
any clues ?
no probe file created
Re: no probe file created
Hi,
I believe the M40 line in your gcode will create a blank file but it remains empty until its closed with M41.
So it should
1. Create the file with M40
2. Do some probing
3. Write the probe results and close the file with M41
In short, the file will be empty until it gets to the M41 line
I believe the M40 line in your gcode will create a blank file but it remains empty until its closed with M41.
So it should
1. Create the file with M40
2. Do some probing
3. Write the probe results and close the file with M41
In short, the file will be empty until it gets to the M41 line
http://www.autoleveller.co.uk/. Software to probe and adjust a GCode file for PCB's or any probe-able surface.
http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.
-James
http://www.autoleveller.co.uk/cnc-probe-guide/. A short guide to setting up the probe.
-James