excuse my English goggle
I am testing autolevel 9.5u2 with mach3
but I have to make a mistake at one place.
1- I charge my original gcode
2- I click on "autolevel" it does my file "ALmonfichier"
3- I load "ALonfile" in mach 3 and start the procedure
and the probing is done correctly
4- the program asks me to remove the probe
M0 (Detach any clips used for probing)
5- by no means he ask me to save a file
below M0, I have GCODE
Code: Select all
(dessous.nc_12000_250_0.16_0.01)
G21
G90
G94
F250.00
G00 Z1.0000
M03 S12000
G4 P3
G00 X2.1000Y-1.2680
#102=[#506+0.05691*#503-0.05691*#506]
#101=[#507+0.05691*#504-0.05691*#507]
#100=[#102+0.11409*#101-0.11409*#102]
G01 Z[#100+-0.0100]
......
..... etc
gilles